BIB J40 Manual Mode

BIB J40: Manual Mode

How to Switch the Robot to Manual Mode

  1. Click and hold in the "M/A" button on the top of the robot until the light turns on around the button.
  2. Pull up on the black handle.
  3. Pull back the red handle locks on both sides of the robot where the handle attaches.
  4. Reverse these steps to get the robot out of manual mode.

How to Start a Manual Cleaning Task

  1. Perform steps 1-3 above.
  2. Click on "Manual Clean" on the main screen.
  3. Click "OK" when the popup appears.
  4. Click what type of cleaning task you would like to perform. 
    1. Ex. sweep, vacuum, scrub, etc.
  5. Click what intensity of cleaning you would like the robot set on.
  6. Click "Start Task" to begin.
  7. The robot can now be manually pushed for that task.

Still need help? Click "Submit a Ticket" at the bottom of the page.
You can also call our tech support office at 724.799.8157.

    • Related Articles

    • AutoXing Robot Models: Cruise Mode

      Cruise Mode Set Up Cruise mode allows the robot to travel the same route and stopping points for as long as needed. 1. To put the robot in Cruise Mode, click the red button on the top right corner of the robot screen. 2. Choose "Cruise" from the ...

    • BIB J40: System Settings Overview

      What Can Be Done in System Settings? Instructional Video Link Volume level changes Charging threshold changes Cleaning part speed changes Only change if instructed from support Software updates WIFI connections Still need help? Click "Submit a ...

    • BIB J40: Bottom Icons Overview

      Instructional Video Link Restart Button Click the grey rectangle on the left side of the robot's screen. Click the "Restart" button to restart the robot. Consumables Button The buttons in this section can be used to lower or raise the squeegee/roller ...

    • AutoXing Robot Models: Delivery Modes

      Different Delivery Modes Quick: Choose up to 4 different locations at once for the robot to travel to. The robot will go to the locations in the quickest, most efficient order. It will NOT go to them in the chosen order. Multi-Point: Choose an ...

    • AutoXing Robot Models: Adjusting Delivery Stop Time

      Delivery Stop Time The delivery stop time or "countdown time" is how long the robot will stay at a delivery before it departs for either the next delivery or standby point. If the delivery is not "finished" (someone does not click on the button on ...