BIB J40 How to Clean the Roller Brush and Waste Bin

BIB J40: Clean the Roller Brush and Waste Bin

How to Clean the Roller Brush and Waste Bin

Steps

  1. Remove the lower right side panel of the robot.
  2. Remove the two screws holding the roller brush module on.
  3. Pull out the roller brush module.
  4. Pull the waste bin out of the module

Frequency

Clean these parts multiple times a day when first using the robot then clean the roller brush every 3 days and the waste bin daily.

Still need help? Click "Submit a Ticket" at the bottom of the page.
You can also call our tech support office at 724.799.8157.

    • Related Articles

    • BIB J40: Replace the Roller Brush

      How to Replace the Roller Brush Instructional Video Link Steps Remove the lower right side panel of the robot. Remove the two screws holding the roller brush module on. Pull out the roller brush module. Take out the old roller brush and remove the ...

    • BIB J40: Clean the Roller Mop Filter Box

      How to Clean the Roller Mop Filter Box Instructional Video Link Steps Remove lower side panels from the robot. Pull out the pipe from the bottom right of the robot. Loosen the screw on the bottom left of the robot located behind the roller mop. ...

    • BIB J40: Clean the Dust Bin and HEPA Filter

      How to Clean the Dust Bin and HEPA Filter Instructional Video Link Steps Open the lid of the robot. Open the lid of the dirty water tank. Remove the vacuum dust bin. Empty the dust bin contents into the trash. Remove the 2 part HEPA filter from the ...

    • BIB J40: Clean the Dirty Water Tank

      How to Clean the Dirty Water Tank Instructional Video Link Steps Remove the dirty water tank from the inside of the robot. Open the cover of the tank and remove any excess waste water. Fill the tank 1/2 way with clean water. Close the cove rand shake ...

    • BIB J40: Replace the Side Brushes

      How to Replace the Side Brushes Instructional Video Link Steps Press the side brush down to remove it. Push the new side brush up into the empty slot. Rotate the side brush to check if the install went well. Repeat these steps on the 2nd side brush. ...